LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> 718 Boxster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (4X Chassis - General 2.5L -- 982 - BOXSTER/CAYMAN) >> WM, 4X00IN Lifting The Vehicle >> Lifting The Vehicle

Lifting The Vehicle

WARNING: This page is about a different variant/trim than selected.
  1. Drive vehicle onto the lifting platform. Pay particular attention to the following:
    • When driving onto a lifting platform, ensure that there is sufficient distance between the lifting platform and the vehicle.
    • If work has to be done in the front footwell, the vehicle should be positioned in such a way that the doors can be opened far enough.

    Information 

    • Under no circumstances should the vehicle be lifted by the engine, transmission or axles. 
    • To avoid damage to the door sills and sill covers, turn up the mounting plates on the lifting platform. 
    1. 2.1  Align the support plate of the lifting platform so that it lines up with the illustrated jacking point -arrow-  . Repeat the procedure on the other side.
      G14948562Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Front jacking point

    2. 2.2  Align the support plate of the lifting platform so that it lines up with the illustrated jacking point -arrow-  .

      Repeat the procedure on the other side.

      G14948563Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Jacking point rear