Teaching While Driving

WARNING: This page is about a different variant/trim than selected.

A procedure in > 9818 - PIWIS Tester II can be used to teach the wheel IDs while driving: »Tyre Pressure Monitoring (TPM) system «»Maintenance/repairs«»Teach wheel IDs«»Teach wheel IDs while driving«.

The wheel IDs can also be taught without using the System Tester.

The following points must always be observed

Allow an idle time of at least 5 minutes before teaching the wheel IDs (wheel electronics units are then in Sleep mode).
Briefly accelerate the vehicle to over 25 km/h (15 mph) in order to teach the wheel IDs (wheel electronics units are then in Burst mode).
Then continue driving at any speed (even < 25 km/h or 15 mph) for max. 10 minutes.
Teaching was successful if a pressure reading is displayed in the instrument cluster for all wheel positions.