LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> 718 Boxster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (40 Wheel Suspension Front Drive Shaft 2.5L -- 982 - BOXSTER/CAYMAN) >> WM, 401819 Removing And Installing Diagonal Arm >> Removing And Installing Diagonal Arm >> Installing Diagonal Arm

Installing Diagonal Arm

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order.

    Observe specified tightening torques:

    Diagonal arm to body: > Initial tightening 90 Nm (67 ftlb.)  > Final tightening + 180° 

    Diagonal arm to lower trailing arm: > Tightening torque 160 Nm (118 ftlb.) 

scientia non olet · About LEMON Manuals