Subsequent Work

WARNING: This page is about a different variant/trim than selected.

Only for 2.5-liter engines: Convert vibration damper.
1. 1.1 Fit vibration damper (2.5-liter engine) with new screws.
2. 1.2 Tighten screws and secure vibration damper using > T10172A - Counter-hold tool .
  Step 1: > Initial tightening 3 Nm (2 ftlb.)
  
  Step 2: > Initial tightening 8 Nm (6 ftlb.)
  
  Step 3: > Torque angle 90° +/- 5°
Fit and tension the drive belt.
> 137801 CHECKING DRIVE BELT .
Install pressure pipe.
> 214119 REMOVING AND INSTALLING PRESSURE PIPE - article on "Installing".
Install rear wall cover.
> WM, 555919 REMOVING AND INSTALLING REAR WALL FLAP
Fit spark plugs.
> 287020 REMOVING AND INSTALLING SPARK PLUGS .
Complete the vehicle.