LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> 718 Boxster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (20 Fuel Supply, Actuator 2.5L -- 982 - BOXSTER/CAYMAN) >> WM, 203819 - Removing And Installing Supply Line (Engine) >> Installing Supply Line (Engine)

Installing Supply Line (Engine)

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1 Screws for supply line holder: > Tightening torque 13 Nm (9.5 ftlb.) 
    2. 1.2 Screw for cable duct: > Tightening torque 8 Nm (6 ftlb.) 
scientia non olet · About LEMON Manuals