LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> 718 Boxster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (17 Engine - Lubrication 2.5L -- 982 - BOXSTER/CAYMAN) >> WM, 174019 - Removing And Installing Oil/Water Heat EXCHANGER >> Installing Oil/Water Heat EXCHANGER

Installing Oil/Water Heat EXCHANGER

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order to removal.

    Fastening screws for heat exchanger (M6 x 20) > Tightening torque 13 Nm (9.5 ftlb.)  .

    Fastening screw for cable duct (M6 x 30) > Tightening torque 13 Nm (9.5 ftlb.)  .

    Fastening screw securing oil separator to heat exchanger > Tightening torque 10 Nm (7.5 ftlb.)  .

scientia non olet · About LEMON Manuals