Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Oil pressure pipe to crankcase and oil pump | Torx screw, M6 x 16 (10.9) | Tightening torque | 13 Nm (9.5 ftlb.) | ||
| Oil pump to crankcase | Torx screw, M6 x 80 (10.9) | Tightening torque | 13 Nm (9.5 ftlb.) | ||
| Oil pump to crankcase | Torx screw, M6 x 30 (10.9) | Tightening torque | 13 Nm (9.5 ftlb.) | ||
| Oil pump sprocket - Step 1 | Internal Torx, M8 x 22 (8.8) - replace screw | Initial tightening | 5 Nm (3.5 ftlb.) | ||
| Oil pump sprocket - Step 2 | Internal Torx, M8 x 22 (8.8) - replace screw | Initial tightening | 17 Nm (13 ftlb.) | ||
| Oil pump sprocket - Step 3 | Internal Torx, M8 x 22 (8.8) - replace screw, set threshold torque of 20 Nm (15 ftlb.) | Torque angle | 90° |