Teaching Remote Control For Auxiliary Heating
NOTE:
Voltage drop
- Irreparable damage to control unit
- Damage to control unit
- Fault entries in the control unit
- Control unit programming/coding is aborted
- Malfunctions in the control unit, even during programming/coding
→ Switch off ignition before disconnecting the control unit.
→ Make sure that the power supply is not interrupted during programming/coding.
→ Connect the battery charger with at least > current 90 A to the vehicle battery.
Information
- Aux. heater remote control can only be programmed using PIWIS Tester.
- A maximum of four remote controls can be programmed per vehicle.
Information
The PIWIS Tester instructions take precedence since the description may be different with later Tester releases.
The procedure described here has been structured in general terms. Different text or additional information may appear on the PIWIS Tester .
Information
- The "look" of the remote control and the teaching process was changed during model year 2018.
- Connect the Tester to the vehicle and start it. Switch on ignition.
- Select the vehicle type if necessary.
- Select the Auxiliary heater (fuel) control unit in the overview. Press F12 to continue. The message "Create Vehicle Analysis Log (VAL)?" appears. Press F11 to continue.
- Select Maintenance/repairs . Press F12 to continue.
- Select Teach remote control for auxiliary heating.
- Teach remote control.
- Press and hold button -1-
on the remote control.
Remote control for auxiliary heating - old version
1 Menu button 2 OK button - Press F8 to start the teaching process on the Tester.
- To program other remote controls, repeat the process.
- Exit the diagnostic application. Switch off ignition. Disconnect the Tester from the vehicle.
- Carry out a function test on the remote control.