LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 85 (15 Engine - Cylinder Head, Valve Drive 4.0L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 153319 Removing And Installing Lower Chain Housing Cover (V8 BITURBO) >> Removing Chain Housing Cover

Removing Chain Housing Cover

WARNING: This page is about a different variant/trim than selected.
  1. Remove crankshaft-flywheel sealing ring -1-  using > T20143 - extractor tool-2-  .

    > 135955 REPLACING CRANKSHAFT-FLYWHEEL SEALING RING

    G15824526Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Crankshaft/flywheel sealing ring

  2. Remove chain housing cover.
    1. 2.1 Loosen and unscrew screws in the sequence -19 to 1-  .
    2. 2.2 Fit screws at the screw points -arrows-  and screw in uniformly by half a turn each in order to press off the chain housing cover.
    3. 2.3 Remove chain housing cover.
    Fig 1: Chain Housing Cover Screws Loosening Sequence
    G15824527Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Chain housing cover

scientia non olet · About LEMON Manuals