Removing (Right) Oil Mist Separator
WARNING: This page is about a different variant/trim than selected.
- Press release button on both sides on both adapters -1-
and disconnect vent lines -2-
on the (right) oil mist separator.
Disconnecting vent lines on (right) oil mist separator
- Remove (right) oil mist separator -1-
.
- 2.1 Press heat shield aside until screws -2-
on the (right) oil mist separator -1-
are accessible.
Information
Screws on the oil separator are permanently connected. If screws are damaged, press the screws out of the oil separator and replace them.
- 2.2 Loosen screws -2- .
- 2.3 Remove (right) oil mist separator -1- .
Removing (right) oil mist separator
- 2.1 Press heat shield aside until screws -2-
on the (right) oil mist separator -1-
are accessible.