Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Screw securing oil intake tube to oil pump | M6 x 26 | Initial tightening | 8 Nm (6 ftlb.) | ||
| Screw securing oil intake tube to oil pump | M6 x 26 | Final tightening | + 90° | ||
| Screw securing shaft cover to oil guide housing | M6 x 16 (2 ea.) | Tightening torque | 9 Nm (6.5 ftlb.) | ||
| Screw securing oil guide housing to crankcase | M6 x 22 (19ea.)/replace, observe tightening sequence | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil guide housing to crankcase | M6 x 22 (19ea.)/replace, observe tightening sequence | Final tightening | + 90° | ||
| Screw securing chain housing cover to oil guide housing | M6 x 25 (6ea.)/replace, observe tightening sequence | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing chain housing cover to oil guide housing | M6 x 25 (6ea.)/replace, observe tightening sequence | Final tightening | + 90° | ||
| Screw for deflection roller (air-conditioning compressor) | M8 x 37/replace | Tightening torque | 25 Nm (19 ftlb.) |