Assembling Steering Wheel

Information 

Multi-functional switches can be used immediately after installation. They do not need to be coded.

1. Installation is performed in reverse order. Pay particular attention to the following:

   Tightening torque for screws on rear cover: >Tightening torque 2.7 Nm (2 ftlb.) 

   Tightening torque for screws on rocker switches: >Tightening torque 2.5 Nm (2 ftlb.) 

   Tightening torque for screws on main cover: >Tightening torque 2 Nm (1.5 ftlb.) 

   Tightening torque for screws on multi-functional switches: >Tightening torque 0.45 Nm (0.25 ftlb.) 

   Tightening torque for screws on contact bridge: >Tightening torque 6 Nm (4.5 ftlb.)