LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (19 - Engine - Cooling 2.9L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 194019 Removing And Installing Coolant Reservoir >> Installing Coolant Reservoir

Installing Coolant Reservoir

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:

    Screw in and tighten screws for coolant reservoir > Tightening torque 8 Nm (5.9 ftlb.) 

    Tightening torque for nut on positive cable (jump-start terminal): > Tightening torque 9.7 Nm (7.5 ftlb.) 

scientia non olet · About LEMON Manuals