Subsequent Work
WARNING: This page is about a different variant/trim than selected.
WARNING:
Incorrect handling of high-voltage components
- Electric shock
- Short circuit
- Fire
- Explosion
→ Only appropriately trained and authorized persons may work on high-voltage vehicles and components.
→ Required qualification: high voltage technician or high voltage expert.
→ Observe national requirements and legislation for this work.
→ Always use insulated tools, such as an > VAS 6883 - insulated tool set when working on these parts.
→ Observe general warning notices for working on the high-voltage system.
→ > 2X00IN GENERAL WARNING NOTICES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM
- Install high-voltage charger.
- Install subwoofer.
- Install rear wheel housing liner at the left.
> WM, 536919 REMOVING AND INSTALLING REAR WHEEL HOUSING LINER
- Install side section flap.
- Start the vehicle again and complete the relevant documentation.
- Complete documentation.
- Read out the fault memory and erase it if necessary.