Subsequent Work
- Electric shock
- Short circuit
- Fire
- Explosion
→ Only appropriately trained and authorized persons may work on high-voltage vehicles and components.
→ Required qualification: High voltage technician or high voltage expert.
→ Observe national requirements and legislation for this work.
→ Always use insulated tools, such as an > VAS 6883 - insulated tool set when working on these parts.
→ Observe general warning notices for working on the high-voltage system.
> 2X00IN GENERAL WARNING NOTICES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM
- Vehicles with particle filter
, install right particle filter:
> Refer to the appropriate Service Information for Removing and installing particle filter (V8 biturbo)
> Refer to the appropriate Service Information for Removing and installing particle filter (V6 Turbo)
- Vehicles without particle filter
, install right catalytic converter:
> Refer to the appropriate Service Information for Removing and installing catalytic converter (V8 Biturbo)
> 267319 REMOVING AND INSTALLING CATALYTIC CONVERTER (V6 BITURBO)
- Only V8 Hybrid:
Install purge-air duct on bottom right side.
> Refer to the appropriate Service Information for Remove and install shield on catalytic converter (V8 Biturbo)