Installing Battery Sensor
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
Tightening torque for nut securing ground strap to body: > Tightening torque 15 Nm (11 ftlb.)
Tightening torque for battery ground line: > Tightening torque 3.5 Nm (2.5 ftlb.)
Tightening torque for screws on cover: > Tightening torque 1.5 Nm (1.1 ftlb.)
- Installation is performed in reverse order. Pay particular attention to the following:
Screw in and tighten fastening nut securing ground line to body > Tightening torque 10 Nm (7.5 ftlb.)
Secure positive terminal on the battery > Tightening torque 6 Nm (4.5 ftlb.)