Intake-Air Distributor (V6 Biturbo)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Intake-Air Distributor Components Location With Torque Specification - V6 Biturbo

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Intake-air distributor - V6 biturbo

1	Throttle valve
2	Intake-air distributor
3	Seal/Replace if damaged
4	Screw, TP 6 x 45 > Tightening torque 7 Nm (5 ftlb.)
5	Screws, M6 x 45/Observe tightening sequence > Tightening torque 9 Nm (6.5 ftlb.)
6	Pressure sensor
7	Screw > Tightening torque 9 Nm (6.5 ftlb.)

Tightening sequence for intake-air distributor

Fig 2: Intake-Air Distributor Screws Tightening Sequence - V6 Turbo

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Tightening sequence for intake-air distributor - V6 Turbo

1-10	Tightening sequence for intake-air distributor screws - V6 Turbo