WM, 2X00IN Battery Trickle Charge: Information
WARNING: This page is about a different variant/trim than selected.
NOTE:
Using charging cables/jump leads directly on the vehicle battery.
- Risk of damage to battery sensor
→ Always connect charging cables/jump leads to the external power supply for jump-lead starting.
Information
- When working or carrying out tests on the vehicle or when the vehicle is in the workshop, a battery charger with a current rating of at least 90 A must be connected.
- As soon as the vehicle is unlocked, e.g. the vehicle is in the workshop or salesroom, it must be trickle-charged using a battery charger.
Information
When using an original standard vehicle electrical system battery , a charge voltage of 14.4 volts or even 14.8 volts (setting on the charger) can be applied.
- Open protective cover on the positive terminal for jump-lead starting.
- First, connect the positive cable from the charger to the positive terminal.
- Connect the negative cable from the charger to the ground point for jump-lead starting.
- Read operating instructions for the charger.
- Switch off all loads.
- Switch on the charger.