Subsequent Work

WARNING: This page is about a different variant/trim than selected.

Fit new crankshaft sealing ring.
> Removing and installing crankshaft sealing ring
Install air-conditioning compressor bracket -5- .
1. 2.1 Replace screws on air-conditioning compressor bracket.
2. 2.2 Position air-conditioning compressor bracket -5- .
3. 2.3 Fit new screws for air-conditioning compressor bracket -4- and tighten to > Initial tightening 8 Nm (6 ftlb.) and > Final tightening + 90° .
4. 2.4 Install tensioning roller -3- .
  1. 2.4.1 Position tensioning roller -3- .
  2. 2.4.2 Fit screw on tensioning roller -2- and tighten to > Tightening torque 25 Nm (19 ftlb.) .
  3. 2.4.3 Fit dust boot -1- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Air-conditioning compressor bracket
Install air-conditioning compressor.
> Removing and installing air-conditioning compressor
Install vibration damper.
> Removing and installing crankshaft vibration damper
Install oil guide housing.
> Removing and installing oil guide housing (V6 Turbo)