Installing Rear Spoiler

Information 

• The rear spoiler must be extended for installation  .

1. Pull wire harness for rear spoiler through the relevant opening in the lid panel.
2. Fit rear spoiler -1-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Fitting rear spoiler

3. Centre the rear spoiler in the recess.
4. Secure rear spoiler.
   1. 4.1 Screw in nuts -5-  and tighten hand-tight.
   2. 4.2 Screw in screws -4-  and tighten hand-tight.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Securing rear spoiler

5. Secure wire harness -1-  .
   1. 5.1 Clip in retaining clips -3-  .
   2. 5.2 Connect electric plug connection -2-  until it engages securely.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Securing wire harness

   WARNING: Electrically moved components 

   • Danger of limbs being trapped or severed 

     → Switch off electric power to drive motor.

     → Make sure it does not switch on again.

     → Check that there is no electric charge.

6. Retract rear spoiler using > 9900 - PIWIS Tester 3  .
7. Adjust the rear spoiler.

   > 665815 ADJUSTING REAR SPOILER 

8. Secure rear spoiler.
   1. 8.1 Tighten nuts -5-  > Tightening torque 8 Nm (5.9 ftlb.) 
   2. 8.2 Tighten screws -4-  > Tightening torque 8 Nm (5.9 ftlb.) 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Securing rear spoiler

9. Screw in and tighten screws -1-  > Tightening torque 8 Nm (5.9 ftlb.) 

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screwing in screws