Installing Heat Shield For Turbocharger

1. Install heat shield for turbocharger -3-  .
   1. 1.1 Move heat shield -3-  into installation position.
   2. 1.2 Fit and tighten nuts -1 and 2-  .

      Nuts on heat shield, front -1-  : > Tightening torque 5 Nm (3.7 ftlb.) 

      Nuts on heat shield, rear -2-  : > Tightening torque 9 Nm (6.6 ftlb.) 

   3. 1.3 Clip lines for the oxygen sensors -4 and 5-  into the clips -6-  on the heat shield.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Heat shield on turbocharger