Oil Pump And Oil Windage Tray
WARNING: This page is about a different variant/trim than selected.
Oil pump
| 1 | Oil pump > Initial tightening 20 Nm (15 ftlb.) > Final tightening + 90° |
| 2 | Chain guard |
| 3 | Screw, M6 x 20 > Tightening torque 9 Nm (6.5 ftlb.) |
| 4 | Screw, M6 x 60 > Tightening torque 9 Nm (6.5 ftlb.) |
| 5 | Seal/replace |
| 6 | Guide rail for oil pump drive |
| 7 | Oil pump chain |
| 8 | Tensioning rail |
| 9 | Collar axle, M6 |
| 10 | Screw, M6 x 16 > Tightening torque 9 Nm (6.5 ftlb.) |
| 11 | Oil windage tray |
| 12 | Screw, M6 x 20 > Tightening torque 9 Nm (6.5 ftlb.) |
| 13 | Oil pressure control valve |
| 14 | Screw, M6 x 20 > Tightening torque 9 Nm (6.5 ftlb.) |
| not pictured | Screws, M6 x 20 for oil intake tube > Tightening torque 9 Nm (6.5 ftlb.) |