Intermediate Shaft

WARNING: This page is about a different variant/trim than selected.

Fig 1: Intermediate Shaft Components Location With Torque Specification - V8 Turbo

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Intermediate shaft - V8 Turbo

1	Intermediate shaft/oiling bearing locations
2	Coolant pump drive gear wheel
3	Screw, M10 x 20/replace > Initial tightening 15 Nm (11.1 ftlb.) > Final tightening + 45°
4	Thrust bearing
5	Gasket/replace
6	Cap
7	Screws, M6 x 16 > Tightening torque 9 Nm (6.6 ftlb.)
8	Screw M10 x 32/replace > Initial tightening 15 Nm (11.1 ftlb.) > Final tightening + 45°
9	Assembly pin, must be removed following assembly.
10	Bracing gear wheel