Removing Solenoid/Hydraulic Valve For Camshaft Controller

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Unscrew and remove fastening screws for hydraulic valve -4- .

Carefully pull hydraulic valve up and out. To do this, use 9235 - relay puller . Hold hydraulic valve only at the metal body.

Fig 1: Camshaft Control Components Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Camshaft control

1	Screw, M12 Tighten fully after setting valve timing. Always use a new screw
2	Camshaft controller with integrated hexagon for countering
3	Hydraulic valve for camshaft control
4	Screw, M5x 12

Visually inspect hydraulic valve strainer and clean with solvent naphtha if necessary. Replace hydraulic valve if heavily soiled