LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 763 (53 - Body Rear - (95B) - MACAN S) >> WM 534855 Replacing Rear Side Member (Section) >> Subsequent Work >> Subsequent Work For Body Repairs (With Straightening System)

Subsequent Work For Body Repairs (With Straightening System)

WARNING: This page is about a different car, the 2017 Porsche Macan, 2016 Porsche Macan, and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release and remove vehicle from the straightening system.
  2. Clean joint areas and sheetmetal flanges with a wire brush.
  3. Prime joint areas and sheetmetal flanges with 2K primer.
  4. Restore standard seal with body sealant → 5X00IN42 SEAM SEALING .

    Also seal the repair area carefully.

  5. Paint repair area and adjacent surfaces, if necessary.
  6. Restore standard underbody protection with underbody sealant → 5X00IN43 UNDERBODY PROTECTION .
  7. Apply standard cavity preservation → WM 5X00IN CAVITY PRESERVATION . Also carefully apply cavity preservation to the repair area.
  8. Install removed accessories in the repair area.
scientia non olet · About LEMON Manuals