Installing Trim Panel For Rear Lid
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
Check that the fixing clips are not bent or broken.
Replace missing or damaged fixing clips with new ones.
Make sure that all fastening clips have engaged correctly.
Check that they are fitted correctly.
Information
- Bonding surface must be clean and free of grease. Clean with cleaning solution if necessary.
- Installation is performed in reverse order to removal.
- Tighten fastening screws to the specified torque. Tightening torque 2.2 Nm (1.5 ftlb.) +/-0.2 Nm (+/- 0.1 ftlb.)
- Clean bonding surfaces.
- Stick on section Item 7 using double-sided adhesive tape.