Removing Electronic Adjuster For Turbocharger

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Hot components

Risk of burns

→ Let hot components cool down.

→ Wear personal protective gear.

Information

The procedure for removing and installing is described for one side as an example. The procedure for the other side is practically identical.

Disconnect electric connector on electronic adjuster for turbocharger.
1. 1.1. Pull off rubber cap -1- .
2. 1.2. Release connector -2- and disconnect it.
  
  Fig 1: Disconnecting Electric Connector On Electronic Adjuster For Turbocharger
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Loosen actuating rod -1- for electronic adjuster for turbocharger at the top in direction of arrow.

Fig 2: Locating Actuating Rod For Electronic Adjuster
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove protective plate -1- for actuating rod for electronic adjuster for turbocharger.
1. 3.1. Press actuating rod -2- down -arrow- and unscrew screw at the top -3- .
2. 3.2. Unscrew screw at the bottom -4- and remove protective plate -1- .
3. 3.3. Tool recommendation: Socket-wrench insert with ball joint, hexagon socket a/f 5
  
  Fig 3: Locating Actuating Rod Protective Plate For Cylinders 1-3
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove electronic adjuster for turbocharger.
1. 4.1. Unscrew screws -arrows- .
2. 4.2. Remove electronic adjuster -1- .
  
  Fig 4: Locating Turbocharger Electronic Adjuster
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.