Installing Clutch
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Clean the friction surfaces of the flywheel and clutch pressure plate prior to installation with brake cleaner or solvent naphtha.
- Surfaces of friction linings must be free from contamination, especially oil and grease.
Information
- Tighten fastening screws uniformly and in diagonally opposite sequence in several steps.
- Always replace fastening screws.
- Centering mandrel 9102 with the drive plate must be inserted into the guide joint (needle sleeve).
- Fit pressure plate with new screws according to specification.
- 2.1. Tightening level 1: Initial tightening 20 Nm (15 ftlb.)
- 2.2. Tightening level 2: Torque angle 90° +/-2°
- Remove the centering mandrel.