Subsequent Work

Subsequent Work For Body Repairs (Without Straightening System) 

1. Clean joint areas and sheet metal flanges with a wire brush.
2. Prime joint areas and sheet metal flanges with 2K primer.
3. Restore standard seal with body sealant. Refer to WM 5X00IN SEAM SEALS

   Also seal the repair area carefully.

4. Paint repair area and adjacent surfaces, if necessary.
5. Restore standard underbody protection with underbody sealant. Refer to WM 5X00IN UNDERBODY PROTECTION .
6. Apply standard cavity preservation. Refer to WM 5X00IN CAVITY PRESERVATION . Also apply cavity preservation to the repair area.
7. Install removed accessories in the repair area.

Model year as of 2014