Removing Throttle Housing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Intake Module On Naturally Aspirated Engine Components Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Intake module on naturally aspirated engine

1	Intake module
2	Decoupling module (fastening part); observe specified tightening sequence
3	Screw, 5 x 16
4	Pressure sensor
5	Intake module seal; check that seal is aligned and fitted correctly!
6	Heat socket
7	Screw, 6 x 50
8	Electronic accelerator/throttle housing
9	Seal
10	Lan socket

Fig 2: Intake Air Module On Turbo Engine Components Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Intake air module on turbo engine

1	Intake module
2	Decoupling module (fastening part); observe specified tightening sequence
3	Screw, 5 x 16
4	Pressure sensor
5	Intake module seal; check that seal is aligned and fitted correctly!
6	Heat socket
7	Screw, 6 x 50
8	Electronic accelerator/throttle housing
9	Seal
10	Ball socket

Disconnect cable plug on the throttle housing and pull cable out of the clip.
Loosen the four screws on the throttle housing -arrows- . Remove throttle housing.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Throttle adjuster
Check the condition of the sealing ring. Replace sealing ring if necessary >.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Sealing ring for throttle housing