Installing Throttle Housing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

The tightening specifications for the basic engine are stored centrally.

> Refer to 1X00IN Technical values in the appropriate service information

> WM 2X00IN TECHNICAL VALUES (PANAMERA, PANAMERA S, PANAMERA S EXECUTIVE, PANAMERA 4, PANAMERA 4S, PANAMERA 4 S EXECUTIVE)

> 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES AND ASSEMBLY OVERVIEWS

Tightening torques and assembly instructions for other assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.

Fig 1: Intake Module On Naturally Aspirated Engine Components Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Intake module on naturally aspirated engine

1	Intake module
2	Decoupling module (fastening part); observe specified tightening sequence
3	Screw, 5 x 16
4	Pressure sensor
3	Intake module seal; check that seal is aligned and fitted correctly!
6	Heat socket
7	Screw, 6 x 50
8	Electronic accelerator/throttle housing
9	Seal
10	Ball socket

Fig 2: Intake Air Module On Turbo Engine Components Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Intake air module on turbo engine

1	Intake module
2	Decoupling module (fastening part); observe specified tightening sequence
3	Screw, 5 x 16
4	Pressure sensor
5	Intake module seal; check that seal is aligned and fitted correctly!
6	Heat socket
7	Screw, 6 x 50
8	Electronic accelerator/throttle housing
9	Seal
10	Ball socket

Check the condition of the sealing ring. Replace sealing ring if necessary >.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Sealing ring for throttle housing
Place throttle housing in installation position and fit it. Insert and screw in four screws -arrows- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Throttle adjuster mounting
Fit cable plug on the throttle housing and insert cable into the clip.