Removing Side Section Lower Part
WARNING: This page is about a different car, the 2017 Porsche Macan, 2016 Porsche Macan, and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Information
Loosen connection points on one side only. Do not damage the sheet-metal panel underneath.
- Drill out spotwelds using spotweld drill; see Gr. 2.4; Workshop Equipment Manual Nr.129
.
- 1.1. Drill out spotweld -A-
from the inside.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Heat the marked bonding surfaces.
- 2.1. Make a sufficient gap between the side section -1-
and side section lower part -2-.
- 2.2. Remove side section lower part.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|