Installing Cover For Front Underbody
WARNING: This page is about a different car, the 2017 Porsche Macan, 2016 Porsche Macan, and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Installation is performed in reverse order. Pay particular attention to the following:
- Tighten fastening screws for front underbody to Tightening torque 2.5 Nm (1.75 ft lb.) until secure. Torque screwdriver Nr.89 Pos.5
- Tighten fastening screws securing wheel housing liner to underbody panelling to Tightening torque 2 Nm (1.5 ft lb.) until secure.