Left Turbocharger: Removal
WARNING: This page is about a different car, the 2018 Land Rover Discovery and 2017 Land Rover Discovery. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Remove the engine undershield.
Refer to: ENGINE UNDERSHIELD .
- Drain the engine oil.
Refer to: ENGINE OIL DRAINING AND FILLING .
- Remove the exhaust.
Refer to: EXHAUST SYSTEM - VEHICLES WITH: DIESEL EXHAUST FLUID .
- Remove the left Exhaust Gas Recirculation (EGR) valve.
Refer to: LEFT EXHAUST GAS RECIRCULATION VALVE .
Release the intake air pipe.
-
CAUTION: Make sure that the area around the component is clean and free of foreign material.
- Remove the 2 bolts.
- Remove and discard the gasket.
-
CAUTION: Make sure that the area around the component is clean and free of foreign material.
- Remove the turbocharger oil return pipe.
- Remove and discard the gasket.
Remove the turbocharger heatshield.
-
CAUTION: Make sure that the area around the component is clean and free of foreign material.
- Remove and discard the turbocharger oil feed pipe bolt.
- Remove and discard the washers.
Disconnect the Crankshaft Position Sensor (CKP) electrical connector.
Disconnect the electrical connector from the turbocharger.
Remove the 4 bolts.
-
WARNING: Be prepared to collect escaping fluids.
Release the coolant pipe.
-
WARNING: Be prepared to collect escaping fluids.
- Release the coolant pipe.
- Remove and discard the O-ring seal.
Remove the exhaust manifold heatshield.
Remove and discard the nut.
- Remove and discard the nuts.
- Remove and discard the gasket.
- Remove the turbocharger coolant pipe.
- Remove and discard the gasket.