Electric Park Brake Release When The Vehicle Has No Electrical Power: Part(S)

WARNING: This page is about a different car, the 2018 Land Rover Discovery and 2017 Land Rover Discovery. However, it is still accessible from the selected car via links, so may be relevant.

STEP	PART NAME	QUANTITY
Adjustment Step 1	Electric park brake actuator fitting kit	1

CHECK

NOTE:

To be carried out in the event that the vehicle has no electrical power.
Some components shown removed for clarity.
Some variation in the illustrations may occur, but the essential information is always correct.

WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.
Refer to: WHEEL AND TIRE .
CAUTION: Left illustration shown, Right is similar.

Disconnect the electrical connector.
CAUTION: Left illustration shown, Right is similar.

NOTE: Remove and discard the O-ring seal.
CAUTION: Left illustration shown, Right is similar.

Release the caliper as illustrated.
Repeat the above procedure for the other side.
ADJUSTMENT
CAUTION: Left illustration shown, Right is similar.

NOTE: Install a new O-ring seal.

Renew Part: Electric park brake actuator fitting kit Quantity: 1 .

Torque: 11 Nm
CAUTION: Left illustration shown, Right is similar.

Connect the electrical connector.
Calibrate the electric parking brake (EPB) using the diagnostic tool.