Removal And Installation: Removal
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
- Disconnect the battery ground cable
Refer to: SPECIFICATIONS
- Raise and support the vehicle.
- Refer to: TIMING COVER
- Refer to: RIGHT FUEL RAIL
- Refer to: INTAKE AIR SHUTOFF THROTTLE
- Refer to: FUEL INJECTION COMPONENT CLEANING
-
CAUTION: Be prepared to collect escaping fuel.
Install the special tool.
Special Tool(s): 100-012 , 310-213
Special Tool(s): 100-012 , 310-213
Remove the special tool.
Special Tool(s): 100-012 , 310-213
- Remove the 2 remaining fuel injectors.
-
NOTE: This step is only required if new components have not been installed.
-
NOTE: This step is only required if new components have not been installed.
- CAUTION: Make sure that the mating faces are clean and free of corrosion and foreign material.
-
NOTE: Discard the gasket.