LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Macan GTS >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel -- Range Rover/L405) >> Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel >> Oil Cooler >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: Install new seals.

    Install the oil cooler.

    Renew Part: Oil cooler O-ring seals Quantity: 1  .

    Torque Specification: 10 Nm 

  2. CAUTION: Install new seals.

    Install the coolant outlet.

    Renew Part: Engine coolant outlet seal Quantity: 1  .

    Torque Specification: 10 Nm 

  3. Connect the coolant hoses.
  4. Install the vacuum reservoir.

    Torque Specification: 10 Nm 

  5. Connect the vacuum tubes.
  6. Install the glow plugs.

    Refer to: GLOW PLUGS

  7. Install a new oil filter.

    Refer to: OIL FILTER ELEMENT 

  8. Install the right valve cover.

    Refer to: RIGHT VALVE COVER 

  9. Connect the startup battery ground cable.

    Refer to: SPECIFICATIONS

  10. Fill the cooling system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING

  11. Check and top-up the engine oil.
scientia non olet · About LEMON Manuals