Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.

Torque Specification: 7.5 Nm
Torque Specification: 28 Nm
CAUTION: Make sure that new nuts are installed.

NOTE: Install new gaskets.

Renew Part: Exhaust manifold nuts Quantity: 1 .

Renew Part: Exhaust manifold gasket Quantity: 1 .

Renew Part: Crossover pipe gasket Quantity: 1 .
NOTE: Tighten the bolts in the indicated sequence.

Fig 1: Exhaust Manifold Bolts Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque Specification: 24 Nm
CAUTION: Install new studs.

Renew Part: Exhaust manifold cross-over pipe studs Quantity: 1 .

Torque Specification: 24 Nm

CAUTION: Make sure that new nuts and bolt are installed.
Renew Part: Exhaust manifold cross-over pipe nuts and bolts Quantity: 1 .

Torque Specification: 24 Nm
Refer to: LEFT TURBOCHARGER - TDV6 3.0L DIESEL - GEN 2, VEHICLES WITHOUT: HYBRID SYSTEM