LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Macan GTS >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel -- Range Rover/L405) >> Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel >> Camshaft Rear Seal >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
  1. G11601888

    Install with the special tool.

  2. CAUTION: Make sure the seal is installed correctly.
    NOTE: Make sure that the seal is 1mm below the face of the cylinder head.
    G11601889
  3. G11601890

    Remove the special tool.

  4. CAUTION: Only tighten the bolt finger-tight at this stage.
    G11601793
  5. G11601763

    Install the special tool.

  6. G11601764

    Install the special tool.

  7. CAUTION: Make sure the torque wrench setting procedure is followed correctly. Failure to follow this instruction may result in damage to the vehicle.
    G11601796

    Calculate the setting for the torque wrench.

  8. CAUTION: Make sure the torque wrench setting procedure is followed correctly. Failure to follow this instruction may result in damage to the vehicle.
    G11601765
    • Using the special tool, install the camshaft rear pulley retaining bolt.
    • Stage one: Tighten to 80 Nm (59 lb.ft).
    • Stage two: Tighten a further 80 degrees.
  9. Refer to: REAR END ACCESSORY DRIVE
  10. Remove the special tools.
scientia non olet · About LEMON Manuals