Removal And Installation: Removal
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, 2015 Land Rover Range Rover, and 2014 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
After carrying out repairs, the fuel system must be checked visually for leaks. Failure to follow this instruction may result in personal injury.
CAUTION:
Make sure the workshop area in which the vehicle is being worked on is as clean and as dust free as possible. Foreign matter from work on clutches, brakes or from machining or welding operations can contaminate the fuel system and may result in later malfunction.
NOTE:
Removal steps in this procedure may contain installation details.
All vehicles
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: PETROL AND PETROL-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS
- Disconnect the battery ground cable.
Refer to: SPECIFICATIONS
- Refer to: FUEL TANK DRAINING
-
NOTE: Repeat the procedure for the other side.
- Refer to: REAR DRIVESHAFT - V6 S/C 3.0L PETROL/V8 N/A 5.0L PETROL/V8 S/C 5.0L PETROL
Short wheelbase
-
CAUTION: LH illustration shown, RH is similar.NOTE: Repeat the procedure for the other side.
Long wheelbase
-
CAUTION: RH illustration shown, LH is similar.NOTE: Repeat the procedure for the other side.
All vehicles
-
CAUTION: Be prepared to collect escaping fuel.
-
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
Torque Specification: 45 Nm
-
NOTE: Do not disassemble further if the component is removed for access only.
Torque Specification: 10 Nm
Torque Specification: 7 Nm