Removing and installing front drive shaft: Removal
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Before raising the vehicle, undo the drive shaft fastening at the wheel side! Actuate the brake while doing this!
- Remove diagonal brace to facilitate assembly (2 M12 screws)!
- Remove front wheel and underside panel.
- Undo the pan-head screws of the drive shaft on the transmission flange.NOTE:
- The CV joint can come apart if the dust bellows holder -arrow- is removed or damaged. The joint must therefore be secured against falling apart during removal, installation and transport with 8 mm screws + nuts (2 ea.)!
- Disengage air guide on control arm.
- Loosen stabilizer mount at stabilizer (counter with open-ended wrench).
- Undo track rod and control arm on wheel carrier. When loosening the fastening nuts, counter with special tool 9546 (Torx screwdriver)! Press ball joint off control arm -1-
with press-out tool 9560 -C-
and ball joint off track rod -2-
using a commercially available track rod extractor. See Fig 2
.
Courtesy of PORSCHE OF NORTH AMERICA, INC.
- To prevent damage to the rubber sleeves of the ball joints, coat the rubber sleeves and the extractors in this area with tyre mounting paste!
- Push protective tube (shop-made) onto the drive shaft (profile shaft).
- Swivel (pull) spring strut outwards without using excess force and extend drive shaft.
- Since the drive shaft can be moved in the wheel hub toothing only with great use of force, undo the drive shaft using a copper mandrel (driving mandrel)! For unfavorable tolerances, the drive shaft must be pressed out of the wheel hub toothing using a suitable wheel hub extractor!
- Do not damage the boots of the ball joints. Push a transport protective cap onto the joint if necessary.