Hydraulic System Fluid Level Check: Check
WARNING: This page is about a different car, the 2018 Land Rover Discovery Sport, 2017 Land Rover Discovery Sport, 2016 Land Rover Discovery Sport, and 2015 Land Rover Discovery Sport. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Raise and support the vehicle.
Refer to: LIFTING .
- Disconnect the startup battery ground cable.
Refer to: SPECIFICATIONS .
-
CAUTION: Make sure the battery is disconnected. Failure to follow this instruction will cause a Diagnostic Trouble Code (DTC) to be flagged on the vehicle.NOTE: The harness connector on the rear drive unit hydraulic motor has a two stage clip.
Move the clip upwards as illustrated.
Release the clip as illustrated to disconnect the electrical connector.
Remove the fluid filler plug.
-
CAUTION: Make sure the correct specification of oil is used.
Fill the rear drive unit to the level of the of the fill plug.
Refer to: SPECIFICATIONS .
- Install the fluid filler plug.
- Torque Specification: 12 Nm
- Connect the rear drive unit hydraulic motor harness electrical connector.
- Connect the startup battery ground cable.
Refer to: SPECIFICATIONS .