Installing Additional Flap (Module)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Push additional flaps on both sides of the vehicle into the guide pins at the bottom.

Fig 1: Installing Additional Flaps
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Further installation is performed in reverse order to removal.
Tighten fastening screws to the specified tightening torque.
Tightening torque 9.7 Nm (7.5 ftlb.)

Tightening torque 9.7 Nm (7.5 ftlb.)

Tightening torque 9.7 Nm (7.5 ftlb.)