Installing Rear Apron

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

The number of fastening screws, fixing clips, plug connections, holders and trim panels can vary depending on equipment.
The illustrations for removing and installing the drive mechanism are shown only on one equipment variant and may differ from the actual equipment variant.
Some steps must be carried out automatically.
Some of the repair illustrations show only one side of the vehicle.

Fit rear apron with the help of another person.

Fig 1: Fitting Rear Apron
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Clip top of rear apron into the attachment strip.
Connect wire harness on the left side.

Fig 2: Connecting Wire Harness
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Clip sides of rear apron into the attachment strip.

Fig 3: Clipping In Rear Apron At Sides
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw in fastening screws -4- underneath the rear apron and tighten to Tightening torque 3.5 Nm (2.5 ftlb.) .

Fig 4: Securing Rear Apron At Bottom
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw in fastening screws -1- at the sides of the rear apron and tighten to Tightening torque 3 Nm (2 ftlb.) .

Fig 5: Securing Rear Apron At Sides
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw in fastening screws -1- on the wheel housing liner.

Fig 6: Securing Wheel Housing Liner
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position guide pins -3- , screw in fastening screw -2- and tighten to Tightening torque 10 Nm (7.5 ftlb.) .

Fig 7: Fitting Guide Pin
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten fastening screws -1- in frame for light to Tightening torque 3 Nm (2 ftlb.) .

Fig 8: Detaching Rear Apron At Top
Courtesy of PORSCHE CARS NORTH AMERICA, INC.