Installing Front Fabric Lining

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Pull the connection seal of the fabric lining -1- into the roof profile -arrow- .

Fig 1: Pulling Bottom Connection
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull the connection seal of the fabric lining -1- into the plastic cover -2- (-arrow- ) until the plastic cover -2- is exposed by only -dimension X= 60 mm- .

Fig 2: Pulling Top Connection
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Guide plastic cover -1- at the front into the roof assembly -2- (-arrow A- ) and push in the metal clip -3- (-arrow B- ).

Fig 3: Installing Plastic Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure plastic cover -2- at the rear with the fastening screw.
Pull the fabric lining -1- forward -arrow A- until the plastic cover -2 - is covered. Lift the plastic cover up slightly and fit the bead -arrow B- .

Fig 4: Securing Top Connection
Courtesy of PORSCHE CARS NORTH AMERICA, INC.