LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Macan GTS >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (60 - Sliding Roof, Tilting Roof -- CARRERA (997)) >> WM 600655 Replacing Roof Assembly (Frame) >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install holder unit (drive mechanism). → Removing Holder Unit (Drive Mechanism) 
  2. Install wire harness for roof assembly. → INSTALLING WIRE HARNESS FOR CONVERTIBLE TOP 
  3. Install frame for sunroof cover. → Installing Frame For Sliding Roof 
  4. Install air deflector. → Installing Air Deflector 
  5. Install microswitch for closing the sunroof. → Replacing Microswitch For Closing The Sunroof 
  6. Install motor for sunroof at the left and right. → Installing Electric Motor For Sunroof 
  7. Install closing aid. → INSTALLING CLOSING AID
  8. Install wiper motor for rear window washer. → INSTALLING WIPER MOTOR FOR REAR WINDOW WASHER 
  9. Connect roof assembly and vehicle using an adapter cable 9758  .
  10. Adjust microswitch for closing the sunroof. → Adjusting Microswitch For Closing The Sunroof 
  11. Carry out a function test from the vehicle using the adapter cable 9758  .
  12. Connect PIWIS Tester 9718  and read out fault memory; erase the fault memory if necessary.
  13. Install roof assembly. → Installing Roof Module 
scientia non olet · About LEMON Manuals