Installing Transmission-Oil Pump

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Always replace gaskets and O-rings.

Grease all gaskets (except for the cooling system) with Kluber Syntheso Glep (Part No. 000.043.204.68).

Fit O-rings on the transmission-oil pump.
1. 1.1. Grease O-rings with the prescribed lubricant.
Install transmission-oil pump -1- .
1. 2.1. Guide in transmission-oil pump as far as possible by hand. Small twisting movements will make it easier to install the pump.
2. 2.2. Fit the bottom hexagon-head bolt (M8 x 30) -3- as a guide. Tap the oil pump in carefully as far as it will go with a rubber hammer.
3. 2.3. Coat the thread of the two hexagon-head bolts (M8 x 25) at the top -2- with plenty of Loctite 574 (Part No. 000.043.051.00).
4. 2.4. Fit and tighten bolts on the transmission flange.
  → Tightening torque: 23 Nm (17 ft. lb.)
5. 2.5. Remove sealant residue.
  
  Fig 1: Installing Oil Pump On Transmission
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.