Removing Cover For Rear Lock Support

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Cover For Lock Support Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screw out rubber adjustment stop.
1. 1.1. Screw out rubber adjustment stop -1- at the left and right.
  
  Fig 2: Screwing Out Rubber Adjustment Stop
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove cover for rear lock support.
1. 2.1. Unscrew fastening screws -1- and spring washers -2- from the cover for the rear lock support -3- and remove cover for rear lock support -3- in an upward direction.
  
  Fig 3: Removing Cover For Rear Lock Support
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.