LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Macan GTS >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (91 - Radio, Stereo, Telephone, On-Board Computer -- PANAMERA (970)) >> WM 911019 Removing And Installing Pcm Display And Operator Control Unit (Except PANAMERA S Executive, PANAMERA Executive, PANAMERA Turbo Executive, PANAMERA GTS) >> Installing PCM Display And Operator Control Unit

Installing PCM Display And Operator Control Unit

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Plug in electric plug connections -4, 5, 6, 7, 8-  until they engage securely.
  2. Position and insert the central connector -2-  . Close the securing clip -3-  until it engages securely.

    Information 

    Fig 1: Connecting Electric Plug Connections
    G09813743Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Before removing/installing the PCM system, move the gear lever to 4th gear or the PDK selector lever to D.

    This protects the gear lever or selector lever from possible damage from the PCM housing.

  3. Insert the PCM display and operator control unit into the mounting in the dashboard.
    1. 3.1. Carefully insert the PCM display and operator control unit as far as it will go.
    2. 3.2. Make sure that the lines are not pinched.
  4. Secure the PCM display and control unit using the four fastening screws -1-  . → Tightening torque: 7 Nm (5 ftlb.) 
    Fig 2: Tightening Fastening Screws
    G09813744Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals