LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Macan GTS >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (10 - Engine - Crankcase, Suspension -- PANAMERA (970)) >> WM 105519 Removing And Installing Oil Mist Separator (PANAMERA, PANAMERA Turbo, PANAMERA Turbo Executive, PANAMERA Turbo S, PANAMERA Turbo S Executive, PANAMERA GTS) >> Removing Oil Mist Separator

Removing Oil Mist Separator

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Overview Of Oil Mist Separator
G09804282Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Engine ventilation/oil mist separator
  2. Molded seal
  3. Molded seal
  4. Screw elements, M6
  1. Disconnect line connections to the connection piece on the oil mist separator. To do this, press on the grooved surfaces and pull off the connection. -1- 
  2. Loosen screws -2-  . Screws are permanently connected. If screws are damaged, press the screws out of the oil mist separator and replace them.
    3. Fig 2: Identifying Oil Mist Separator
    G09804283Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Remove oil mist separator from the valve cover. At the same time, check the seals and replace them if damaged.
scientia non olet · About LEMON Manuals